Installation Guide

  • The items with HOLES come with several long screws for mounting and 1/4 inch thick spacers, cut from the same plastic, that allow the numbers to seemingly float off the surface.
  • The items with NO HOLES in them for a flush mount, you can use a silicone glue or outdoor permanent double sided tape.

Tools Needed

  • Level
  • Measuring tape
  • Pencil or masking tape
  • High-bond mounting tape or exterior
  • adhesive
  • Phillips or flat screwdriver
  • Hammer (for anchors)

 

1. Prepare the Surface

  • Clean the wall with a dry or alcohol wipe. 
  • Make sure it's smooth, clean, and fully dry.


2. Mark Placement

  • Use a level and pencil/tape to mark where each number/ word will go.
  • Check spacing before mounting, most modern layouts use ½ inch to 1 inch
    between numbers.


3. Mount the Numbers

Option A: Mounting Tape

  • Apply tape to the back of each number.
  • Remove liner and press firmly to the wall for 20–30 seconds.

Option B: Silicone / Glue

  • Apply some silicone dots on the back.
  • Press into place and hold. 
  • Tape temporarily if needed to prevent slipping.
  • Allow to cure 12–24 hours

Option C: Screws

  • Mark drill points using the number, word or letter.
  • Drill holes.
  • Insert the anchors gently with a hammer until they sit flush.